Search
Another Printer Issue
- Tim Ellsworth
- Jun 11, 2017
- 1 min read
I encountered another issue with the Monoprice Mini while printing standoffs for the E-Bike battery assembly. The Bowden tube came out of the quick connect fitting on top of the hot end. I reinserted the tube and it printed fine. I did notice some damage to the tube from removing and inserting the tube during the repair of PLA jams. I had to reinsert the tube with the hot end fully heated to allow for the PLA to extrude out the bottom. I did not catch the problem until about a half inch of PLA had extruded . I will monitor the issue for now but I may need to replace either the Bowden tube or the fitting if it continues.